![Welcome to the NavList Message Boards.](../sx1.jpg)
NavList:
A Community Devoted to the Preservation and Practice of Celestial Navigation and Other Methods of Traditional Wayfinding
Re: How to put a mirror spring in place ?
From: Tony Oz
Date: 2021 Nov 3, 07:36 -0700
From: Tony Oz
Date: 2021 Nov 3, 07:36 -0700
Dear Philippe,
If you ask about springs like here, then my experience is as follows:
- remove the mirror from its' sitting place
- put the screw through the spring's eye and let the screw to enter its' thread - without the mirror
- make sure the screw has made ~2 turns in its' thread
- take the spring by the loop near its' part that should contact the mirror, - and pulling the spring - turn the spring on the screw so it lays on the mirror box's surface near the screw
- do this with all three springs
- insert the mirror in its' sitting place
- holding the spring with something soft (like a piece of sewing thread) - turn it back to the mirror's surface
- tighten all the screws properly
Hope that helps.
Warm regards,
Tony
60°N 30°E