NavList:
A Community Devoted to the Preservation and Practice of Celestial Navigation and Other Methods of Traditional Wayfinding
Re: Periscopic Sextant. Henry Hughes and Son
From: Mike N
Date: 2009 Jul 30, 13:35 -0700
From: Mike N
Date: 2009 Jul 30, 13:35 -0700
I have a USAF type periscopic Kollsman D-1 sextant that requires 28 volts for the averager to work. I tried wiring three 9-volt batteries in series but the averager needed more power than the three batteries provided. I then copied the arrangement twice and then wired the three series of three in parallel and it worked. However, there's significant power drain and the thing is only good for 2 or 3 shots. Mike Nelson Herndon, VA On Jul 29, 6:58�pm,wrote: > Sorry not to reply until now. I have only just found you request. I only look infrequently here. > > Mine is a MkI Hughes periscopic. I would expect them to all have the same connections with later Mark sextants. > There are three pins in a socket, the centre pin being common (Case, earth). �When looking at the pins from the back of the sextant (eyepiece away from you) the left pin is 3V for the bubble lighting, and the right pin is 28V DC for the averager motor. In fact it works from about 12V upwards. > > I have a battery holder for two 1.5V cells which plugs straight into the socket enabling the sextant to be used for single shot sights, hand held, (heavy!) but without the averager. In fact I stand it on a suitable surface at the right height. > > I have powered the averager from a separate power supply to check it and for the fun of it, but do not use it in anger for sights. > > The power arrangements were designed for use with the aircraft fuselage mounting and power supply when connected of course. > > Douglas Denny. > Chichester England. --~--~---------~--~----~------------~-------~--~----~ NavList message boards: www.fer3.com/arc Or post by email to: NavList@fer3.com To , email NavList-@fer3.com -~----------~----~----~----~------~----~------~--~---